Advertisement
Choose message language, set detection timer and
detection sensitivity and adjust message volume.
Attach the sensor unit to base unit.
(1) Turn front marks of base unit and sensor unit to
point in the same direction.
(2) Insert sensor unit into base unit.
(3) Push sensor unit until release lever is locked.
Check operation and area.
To detach the sensor unit,
grip sensor as shown and
slide the release lever.
To lock sensor unit, insert
sensor locking screw into
locking screw hole and
tighten it.
This product gives the following one-shot output only by detecting the flame continuing for the set time of
detection timer.
Power on notice will sound when the power is
turned on. Speaker sounds intermittently 3 times.
When voltage is low, power on notification will not
be heard. Check the power supply.
This function can be confirmed which sensor
activated.
When the sensor activates, the operation LED
lights up for 50 minutes, then the operation LED
lights off automatically 50 minutes after.
* The sensor activates again during the LED is
lighting up, the memory function be retriggered
for other 50 minutes.
* For reset the LED lighting
This product is equipped with installation holes
(Pitch 3.29" or 83.5mm) to make installation easy
and sensor's direction adjustable.
(1) Place the base on the site and
mark X on 2 points 180°
(2) Drive the 2 pcs. of tapping
screws (accessory) leaving
5mm exposed from the
surface.
(3) Adjust the sensor's direction
by turning the base.
(4) Tighten the screws.
In case of low battery, LED flashes every 5 sec.
In this case change the battery for new one immediately.
Battery life is limited to 2 weeks after initial notification.
When volume switch is set
to minimum, the volume
will be mute.
Advertisement
