Chapter 4 System Preparation; Package Inspection And Unpacking; Inspection; Unpacking - THORLABS CC6000 User Manual

Portable Connector
System Preparation
Chapter 4
4.1.

Package Inspection and Unpacking

4.1.1.

Inspection

When your system arrives, check the shipping cartons for wrinkled or damaged corners, holes through the
cardboard or other signs of rough handling or abuse. If you find any signs of damage, insist that the delivery service
make a note describing the damage on the delivery receipt.
NOTE: If your system arrives in very cold weather, allow the boxes to warm to room temperature before opening
them. Exposing a cold unit to a warm room causes condensation that could damage the system. If condensation
forms, wait for the unit to dry completely before setting it up and connecting it to an electrical outlet.
4.1.2.

Unpacking

Carefully open the box, making sure not to puncture too deeply into the box if using a box cutter. Remove the items
from the boxes very carefully. Review the packing list, and check off if received. If any equipment is missing or
damaged, please contact Thorlabs immediately.
Do not open the interferometer. There are no user serviceable parts in this product. Opening the
device will void your warranty. Any modification or servicing of this system by unqualified personnel
renders Thorlabs free of any liability. This device can only be returned when packed into the complete
original packaging, including all foam packing inserts. If necessary, ask for replacement packaging.
4.2.

System Set-Up

Your Interferometer System is fully ready to operate. No programming or extensive application software experience
is necessary. All functions are self-contained and immediate. The following section will help you get your system
up and running. After all items have been carefully unpacked and laid out on an uncluttered sturdy table near a
grounded power outlet, following the procedure below:
1. Remove the interferometer and cables from the box and place on the table.
2. Attach one end of the USB cable to the interferometer. (The other end of the USB cable will be connected
to the computer/laptop during the software installation procedure.)
3. Plug the AC adapter into the back of the interferometer.
4. Plug the AC adapter power cords into a power source.
5. Follow the Software Installation Procedure (see page 9).
Page 7
WARRANTY WARNING
Chapter 4: System Preparation
TTN169162-D02