Table of Contents
Advertisement
SECTION 3 — STAND-MOUNTING THE OMNI TH
3.1 STAND-MOUNTING THE OMNI TH (Optional)
To mount the Omni Tissue Homogenizer to a stand assembly, refer to
the figure and follow these steps:
1. Secure the 24" post by twisting it onto
the base plate until securely tightened.
2. Loosen the locking knob and slide the
included post clamp assembly down over
the end of the post until the clamp is at the
desired height and lock in place.
3. Slide the TH motor into the opening on the
end of the post clamp assembly and push it
down firmly. The unit will lock in place.
4. To remove the TH, press the black button on
the back of the opening of the post clamp
assembly and lift the motor from the cradle.
3.2 INSTALLING ROTOR-STATOR GENERATOR PROBES
Stainless steel rotor-stator generator probes are easily installed to the
Omni TH motor by means of a quarter-turn bayonet mount. Simply
push the generator probe into the motor housing as far as possible,
turn clockwise, and release. Remove the blue protective cap from the
tip of the generator probe and the Omni TH is ready to operate.
Motor Drive
Thumb Screw
Base Plate
9
Motor Brushes
Post Clamp
Assembly
Locking Knob
24" Post
Advertisement
Table of Contents
