PRONAR T663/4 Operator's Manual page 105

SECTION 5
FIGURE 5.5 Adjustment of parking brake cable tension
(1) brake crank mechanism, (2) bow clamp, (3) hand brake cable, (4) guide roller,
(5) expander arm
Lubricate parking brake mechanism (1) and pins of cable guide rollers (4).
Install a new cable.
Install bolts and new securing cotter pins.
Parking brake cable must be fitted carefully.
Thimbles and three clamps must be fitted at the ends of the cable.
Clamps must be tightened. The distances between the clamps may
not be less than 15 mm.
Clamp jaws must be placed on the side of the load bearing cable - see
figure (5.6).
The first clamp should be placed directly on the thimble.
5.13
Pronar T663/4 T663/4 SILO