Installation Instructions - GE Profile CustomStyle PTI22MBML Owner's Manual And Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.361.3400
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at www.GEAppliances.com (in
Canada at www.geappliances.ca) or from Parts and
Accessories, 800.626.2002 (in Canada 1.888.261.3055).
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install the refrigerator on a floor strong enough to
support it when fully loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
)
or
Visit our Website at:
www.geappliances.ca
or
Visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections:
• Sides 1/8
mm)
• Top 1
mm)
• Back 1/2 mm)
If the refrigerator is against a wall on either side, allow a
1/8 (3 mm) door clearance.
When using the trim kit:
If the cabinet is not flush with the enclosure or is
recessed, allow an additional clearance of 1/2 (13 mm)
on the door hinge side and at the top. Ensure proper
door opening:
Preferred
Top of Cabinet
Flush
Enclosure
with
Cabinet
17
Refrigerator
Profile Model 22
www.GEAppliances.com
Allow Additional
Clearance
Enclosure
Top of Cabinet
Flush
Enclosure
5/8
(16 mm)
Enclosure
1 1 ⁄ (38 mm)
2