Reducing Growth Of Mildew In Bathroom - Mitsubishi Electric MJ-E80EX-H Instruction Manual

Reducing Growth of Mildew in Bathroom

This operation reduces the growth of mildew by using MOVE EYE to detect humidity or droplets that remain inside a bathroom
after, for example, you take a bath. This operation can also be used as a measure for tackling mildew in rooms.
Beep
The POWER lamp goes out and the
operating mode indication disappears.
The louvre swings in a wide range until the humidity
drops to 50%. When the humidity drops under
50%, MOVE EYE operates to change swinging
automatically.
The airflow rate cannot be set because it is
changed automatically. It is also not possible to use
this in conjunction with another operating mode or
to set the humidity.
Press the POWER switch (OFF).
Press the DEHUMIDIFY or MOVE EYE
switch.
For effective use, keep the windows and doors of the room closed and do not ventilate the room during operation.
Operation may not be sufficiently effective if the bathroom is spacious or because of the building materials used for
the floor and walls of the bathroom.
Drops of water may remain in places where water collects easily.
Mildew may grow depending on the room conditions and the type of mildew.
Example: Where air circulation is poor such as beneath a container or the like in the bathroom or at the back of a
cupboard or behind furniture in the room.
This operation cannot dry locations where the airflow cannot reach such as inside a bathtub and beneath a container.
This operation cannot remove existing mildew and water scale, or slime in the drain outlet.
If this operation is used in conjunction with the off timer, operation may stop before drying is complete.
Mildew is unable to produce new spores if dried as mycelia. The MILDEW GUARD feature
applies this principle. (However, the spores themselves are resilient to dry conditions.)
Beep
P11
Beep
Install the unit in the dressing room (entrance to
the bathroom).
(Do not install the unit inside the bathroom.)
Adjust the orientation of
the unit so that air flows
toward the whole room.
If water remains in the
bathtub, cover the bathtub.
CAUTION
The unit does not have a drip-proof or water-proof
structure. Water coming into contact with the unit may
After dehumidifying is performed until the
humidity reaches 50%, operation is performed
for approximately 4 hours and then stopped
automatically.
The length of time of operation may change depending
on the temperature and humidity, but the unit will run
for approx. 4 hours at minimum (approx. 6 hours at
room temperature, 20°C, or up to approx. 12 hours at
maximum when this mode is selected.
When the tank is full (FULL lamp lights), the unit
stops dehumidifying and only blows air.
Location to be dehumidified
Bathroom (bathroom Up to approximately 7 m
+ dressing room) of bathroom + dressing room)
Room Up to 12 m
For more effective operation, use the unit within the above ranges.
"Identification of Black Mold"
[Research paper by Dr.K.Abe of the
Environmental Biology Research Center]
Close the window
in the bathroom.
.
Size
2
(size
2