Advertisement
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in
the
Bonus Pack CD
Disc. Thanks
for the help of saving our earth.
Hard Drive IDE Cable x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Bonus Pack CD disc x 1
Norton Anti-Virus CD x 1
This Easy Installation Guide x 1
PART NO: 49.89L01.011
DOC. NO: AK76D-EG-E0105A
1. JP14 Clear CMOS
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pins 1 & pin2.
5. Connect ATX power cable back to connector PWR2.
Pin 1
1
1
Clear CMOS
Normal Operation
(default)
CPU socket
Lever
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
2. Installing CPU
1.
Pull CPU socket lever and up to 90-degree angle.
2.
Locate Pin 1 on the socket and look for a black dot or
cut edge on the CPU upper left. Match Pin 1 and cut
edge. Then insert CPU into the socket.
3.
Press down CPU socket lever to finish CPU installation.
Note: If you do not match the CPU
socket Pin 1 and CPU cut edge well,
you may damage the CPU.
CPU Pin1
Advertisement
