Hamron 005608 Operating Instructions Manual page 20

EN
Fitting with the heatsink inside
the headlight casing
1. Open the headlight casing's rear cover,
remove the original bulb and replace it
with the LED bulb.
FIG. 3
2. For H3, connect the negative terminal's
(cathode) ring cable lug to the original
screw hole. For H1, connect the negative
terminal's (cathode) cable to the vehicle's
chassis ground. Now connect the original
positive terminal (anode pin).
FIG. 4
3. Connect to the original connector. Fit the
ballast with double sided tape and refit
the rear cover.
FIG. 5
Fitting with the heatsink outside
the rear cover
1. Remove the heatsink from the LED bulb
H1/H3 and remove the original lamp. Fit
the LED bulb H1/H3 in the same way as
the original lamp was fitted (possibly with
a lock ring).
FIG. 6
2. Route the wiring out through the original
rear cover, refit the rear cover and screw
on the LED bulb's heatsink firmly on the
LED bulb.
FIG. 7
3. For H3, connect the negative terminal's
(cathode) ring cable lug to the original
screw hole. For H1, connect the negative
terminal's (cathode) cable to the vehicle's
chassis ground. Now connect the original
positive terminal (anode pin). Secure the
ballast with double-sided tape.
FIG. 8
20
INSTALLATION ( H7 )
NOTE:
The following instructions are only a guide.
Fitting with the heatsink outside
the rear cover
1. Remove the heatsink from the LED bulb
H7 and remove the original lamp. Fit
the LED bulb H7 in the same way as the
original lamp was fitted (possibly with a
lock ring).
FIG. 9
2. Route the wiring out through the original
rear cover, refit the rear cover and screw
on the LED bulb's heatsink firmly on the
LED bulb.
FIG. 10
3. Connect all connectors and fit the ballast.
FIG. 11
Fitting with the heatsink inside
the headlight casing
1. Remove the heatsink from the LED bulb
H7 and remove the original lamp. Fit
the LED bulb H7 in the same way as the
original lamp was fitted (possibly with a
lock ring).
FIG. 12
2. Tighten the heatsink firmly clockwise (the
terminal does not need to be extended)
and insert the original connector H7.
Check that the cathode and anode are
connected with the right polarity.
FIG. 13
3. Insert the ballast in the headlight
casing and secure it on the inside of the
headlight casing. Refit the rear cover.
FIG. 14