Troubleshooting - Jura Capresso Impressa J5 Operating Instructions Manual

Fully automatic coffee & espresso center with clearyl water care system
Hide thumbs Also See for Impressa J5:
Table of Contents

Advertisement

FILL
BEANS.
The bean container is (almost) empty. Add beans to the bean
container.
FILL WATER
TANK.
The water tank is (almost) empty. Add water to the water tank.
CLOSE
COVER.
The lid for the ground coffee funnel is open. Close the lid
(Fig. 11)
NOT ENOUGH
PRE-GROUND.
There is not enough pre-ground coffee in the funnel.
See chapter 11.3.
TOO
HOT.
The J5 is too hot to perform a cleaning or decalcifying program.
Use the hot water button and pump a few ounces of water
through the system. Then try again.
CLEAN.
It's time to run a tablet cleaning cycle. See chapter 18.1
DE-SCALE.
It's time to run a decalcifying cycle. See chapter 18.3

22. TROUBLESHOOTING

A. COFFEE IS NOT HOT ENOUGH
See chapter 10.
B. MILK IS NOT HOT ENOUGH
See chapter 12.1.2.
C. NO COFFEE COMES OUT OF THE COFFEE SPOUT
Reason: Beans in bean container are not feeding properly into
the grinder because they are stuck together.
Solution: Open the bean container safety cover (chapter 20.2)
and stir beans.
When using very oily beans pour the beans onto a plate and let
some of the sticky oils evaporate (this will not harm the aroma of
the coffee).
Reason: You used ground coffee in the ground coffee funnel.
The ground coffee was too fine.
Solution: Use ground coffee which is ground somewhat coarser.
Reason: No water is transported through the system.
Solution 1: Remove – if installed – the Clearyl water filter. Place
a cup underneath the frother and push the Hot Water Button
(Fig. 2). If water comes out, try to make coffee again.
Solution 2: Remove the water container and make sure that the
connecting valve is free of any particles (like a coffee bean).
Proceed as under "Solution 1".
Reason: The ground coffee funnel is clogged; the internal brewing
chamber is clogged.
Solution: Place a large cup underneath the coffee spouts and
run one or two extra rinse cycles.
READY
• Push and hold the Rotary Button until the display shows
RINSE.
• Push the Rotary Button again. The display shows
and the machine pushes hot water through the coffee spouts
and returns to READY.
• Repeat if necessary.
32.
RINSING

Advertisement

Table of Contents
loading

Table of Contents