H-KING Hellcat Little Nugget Instruction Manual page 9

Radio installation:
Use the supplied hook and loop
1
self-adhesive tape to secure your
chosen receiver to the inside of the
radio compartment. We recommend
that you now setup your radio and
the servo throws etc.
WARNING:
DO NOT INSTALL THE PROPELLER ONTO YOUR PLANE UNTIL THE RADIO SETUP HAS BEEN
COMPLETED. ALSO, ALWAYS TURN YOUR TX ON FIRST AND ENSURE THAT THE THROTTLE
STICK IS IN THE LOW POSITION BEFORE PLUGGING IN YOUR FLIGHT BATTERY TO THE
ESC. THEN WHEN YOU HAVE FINISHED FLYING OR SETTING UP ALWAYS UNPLUG THE
FLIGHT BATTERY FIRST BEFORE SWITCHING OFF YOUR TX.
Switch on your TX, then connect your flight battery to the ESC power cable with the XT60
2
connector.
Elevator control surfaces setup: First set the servo trimmer on your TX radio to the center
3
position. Then loosen the stopper screw and ensure the servo horn is perpendicular to the
pushrod as shown. Secondly, ensure that the elevator control surface is perfectly level. Apply a
drop of Loctite glue to the thread of the stopper screw and hand tighten.
Finally, move the elevator control stick on your TX to check that it moves freely with no binding.
4
Once you are happy with this then set the end points to the recommended throws below.
5 Repeat this process for all the other control surfaces.
NOTE:
For binding your radio, and for setting up the servo reverse, subtrims, and end point adjustments, etc,
please consult your R/C instruction manual.
1 7