Clock And Language Setting - Can-Am Spyder ST Series Manual

SETUP
Ending a B.U.D.S. Session
NOTICE After a problem has been solved, en-
sure to clear the fault(s). This will properly re-
set the appropriate counter(s).
1. Click on FAULT tab and check if there are active
faults. If so, service vehicle then clear the faults
in B.U.D.S
2. Click on WRITE DATA button to transfer new
settings and information to the modules.
vmr2006-012-100_ben
WRITE DATA BUTTON
3. Click on EXIT button (right most) to end session.
4. Reinstall DCL connector into its housing.
5. Reinstall service cover on vehicle.

Clock and Language Setting

It is normal that the check engine indicator
NOTE:
lamp is displayed while the clock is adjusted.
Use the RECC (Roadster Electronic Command
Center) to control the display functions.
rmo2010-001-020_a
1. RECC
Pressing the MODE button will move a selection
through the category icons, located at the top left
area of the screen, in this order: Default riding
screen, Audio, CB, Trip meter and Preferences.
38 / 41
Each press of the button will move the selection
to the next available icon. When an icon is se-
lected, its related screen will appear.
The audio and CB icons are skipped when
NOTE:
the vehicle is not equipped with these features.
The Preferences screen is skipped when the ve-
hicle is above 5 km/h (3 MPH), except for the SE5
model for the towing mode.
2
rmo2010-001-015_ben
1. Category icons
2. Default riding icon selected
In the preferences screen, select the appropriate
category.
rmr2010-030-058_aen
PREFERENCES SCREEN
1. 1 st column: Main category
2. 2 nd column: Secondary category or item
3. 3 rd column: Unit or setting
Use the LEFT/RIGHT button to select the desired
column.
Use the UP/DOWN button to move to the desired
item in the column.
Use the RIGHT button to moved to the options
column to the offered for that selection.
2014-3
1
PREDELIVERY