Rear Fender - Can-Am Spyder ST Series Manual

rbl2013-003-017_a
1. Nuts
You can move windshield along the tracks
NOTE:
to facilitate installation of nuts.
rmo2013-003-013_a
3. Torque windshield retaining nuts.
PART
Windshield retaining nut

Rear Fender

Before applying any torque, install all nuts
NOTE:
and screws.
ST LTD Models Only
Remove rear saddlebag kit.
All Models
1. Remove rear fender packaging.
2. Loosen LH and RH fender support screws.
PREDELIVERY
SPECIFIED TORQUE
2.5 N•m ± .5 N•m
(22 lbf•in ± 4 lbf•in)
rbl2013-002-012_a
LEFT SIDE FENDER SUPPORT
1. Screws, washers and nuts
3. Pre-assemble rear fender to its LH and RH rear
fender brackets with M6 x 12 screws, flat plas-
tic washers and M6 nuts (on back side).
rbl2013-002-013_a
1. Rear fender
2. Support
3. M6 x 12 Screws, washers and nuts
Do not torque screws.
NOTE:
4. Connect license plate light connector.
5. Secure license plate light harness inside RH
rear fender support using 4 locking ties (from
PDI kit) into factory installed retainers.
2014-3
PARTS TO BE INSTALLED
23 / 41