Parts To Be Installed; Front Cargo Module - Can-Am Spyder ST Series Manual

rbl2013-003-009_a
TYPICAL
1. Wood piece
rbl2013-003-010_a
TYPICAL
1. Wood piece removed earlier
3. Remove the piece of wood from behind the rear
wheel.
rbl2013-003-011_a
TYPICAL
1. Wood piece behind rear wheel
4. Carefully remove pieces of wood positioned
earlier behind the front wheels.
5. With the help of your assistant, move vehicle
rearward out of the crate base.
PREDELIVERY
rbl2010-002-021_a
TYPICAL
NOTICE
Always move vehicle rearward out of
the crate base.

PARTS TO BE INSTALLED

Front Cargo Module

Make sure battery is not connected before
installing front cargo module. Do not install
front cargo module if battery is connected
because sparks can occur if tools touch bat-
tery terminals.
1. Unlock and lift seat to full open position.
2. Remove LH and RH upper side panels.
2.1 Cut locking tie retaining upper side panel.
Remove panel nut and screw.
Keep panel screws and nuts for instal-
NOTE:
lation further in procedure.
rbl2013-002-018_a
TYPICAL - BRAZIL MODELS
1. Locking tie
2. Panel screw
3. Panel nut
2014-3
PARTS TO BE INSTALLED
WARNING
11 / 41