Vitek VT-1802 R Manual Instruction page 4

ENGLISH
dust, for example, of plaster, concrete, flour
or ashes.
•
Do not use the vacuum cleaner if:
cloth/paper dustbag is not installed;
–
inlet and outlet filters are not installed.
–
•
Regularly check the integrity of power cord
and plug.
•
Do not use the unit if the power plug or cord
is damaged, when the unit malfunctions or
after it was dropped. Do not try to repair the
unit by yourself. Contact an authorized ser-
vice center for all repair issues.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
Safety measures
•
If the suction power of the vacuum cleaner
decreases rapidly while cleaning, switch it
off immediately, remove the power plug from
the socket and check the telescopic pipe and
the flexible hose for obstruction. Remove the
obstruction and only then you can continue
cleaning.
•
Do not use the vacuum cleaner near hot
surfaces, ashtrays and in the places where
inflammable liquids are stored.
•
When unplugging the unit, always hold the
power plug, do not pull the power cord.
ASSEMBLING OF THE VACUUM CLEANER
After unit transportation or storage at low
temperature it is necessary to keep it for at
least two hours at room temperature before
switching on.
•
Unpack the vacuum cleaner completely and
check it for damages.
•
Before using the unit, make sure that your
home mains voltage corresponds to the vac-
uum cleaner operating voltage.
•
Always switch the vacuum cleaner off and
unplug it while replacing the brush-attach-
ments and during the maintenance.
Attaching and removing of the flexible hose
•
Insert the flexible hose ending (7) into the air
inlet (9).
•
Insert the hose until click, indicating prop-
er connection. To remove the flexible hose
press the clamps (8) and detach the hose.
Attaching of the telescopic pipe and attach-
ments
•
Attach the telescopic extension pipe (4) to
the flexible hose handle (5).
•
Extend the lower part of the telescopic exten-
sion pipe to the required length, having pre-
liminary pressed the lock (3).
•
Select the required attachment: floor/carpet
brush (1) or combined attachment (24) and
attach it to the telescopic extension pipe (4).
USING OF BRUSH ATTACHMENTS
Floor/carpet brush (1)
Set the switch (2) on the brush (1) to the required
position (depending on the type of the surface
being cleaned).
Combined attachment (24)
•
This attachment is intended both for
cleaning radiators, crevices, corners and
spaces between cushions and for collect-
ing dust from furniture surface as well,
pile prevents damage of polished furniture
surface.
Using of cloth (23) or paper (26) dustbag
• Open the dustbag compartment lid (11) by
pushing the clamp (10).
•
Remove the dustbag holder (22) pulling it
upwards, install the cloth (23) or paper (26)
dustbag into the holder (22) and then install
the holder (22) back to its place.
•
Close the dustbag compartment lid (11).
Note: On the dustbag compartment lid (11)
there is a block that does not allow to close the
lid (11), if the dustbag (24 or 27) is not installed
or installed improperly; always check if the
dustbag is installed correctly before closing
the lid (11).
Removing of cloth (23) or paper (26)
dustbag
•
Open the dustbag compartment lid (11) and
remove the dustbag.
•
The cloth dustbag (23) is reusable, remove
the dust and garbage from the dustbag, slid-
ing the plastic clamp; then install the clamp
to its place.
•
The paper dustbag (26) is disposable, dis-
pose of the dustbag when it is filled up.
4