Preparing The Chuck For Mounting On Machine Tool; Preparing The Chuck For Operation - Bison 2500 Instruction Manual

Chuck adapter plate and ring bracket
6.2 Preparing the chuck for mounting on the machine tool
To mount the chuck on the machine tool, please proceed as follows:
■ open the package,
■ check the delivery for completeness,
■ remove the distributor ring from the chuck,
■ lift the chuck using an eyebolt and remove from
the package,
■ place the chuck down in a position preventing its
movement,
■ lift the chuck with the crane using an eyebolt,
!
NOTE: Placing the chuck onto the jaws is
strictly forbidden!
10
The workstation should be equipped with the
compressed air connection, that contains a connector
block and shut-off valve (block valve).
The control system and tooling, operator should get
by himself or order.
For controlling, use the 2-way, 3-position valve in
a mid-position, connecting the chamber with the
atmosphere. (Fig. 4).
Control valve diagram
!
NOTE: The manufacturer does not provide
any
switches that work with chuck control
devices as well as any parts working with
Fig. 3
proximity switch devices.
■ place the distributor ring onto the chuck,
■ center the spindle towards to chuck, so the control
device arbors hit the appropriate holes of Ø14mm in
the adapter plate,
■ mount the chuck to the adapter plate,
■ mount the distributor ring,
■ check, whether during rotation the chuck does not rub
the ring, if it does then needs to be centered,
■ when dismounting from the machine tool, please
proceed in the reverse order.
4 2
3 1
pneumatic equipment,
Fig. 4
proximity