Paramount Fitness MDX-R3 Owner's Manual And Installation Manual page 9

Hide thumbs Also See for MDX-R3:

Pool Base Install

Finish pool base even with upper edge of MDX-R3 sump (Fig. 1).

Liner Install

1. Make sure bottom gasket is in place before installing liner.

2. Set liner in pool and draw tight with vacuum.

3. Install top gasket, seal ring and 12 screws.

4. Cut out liner inside of sump. Be sure to trim liner right up to the inside diameter of seal ring.

Assemble the drain PRIOR TO ADDING WATER

NOTICE

of the pool in which the SOFA is installed.

1. Remove 4" pressure plug.

2. SOFA components and fastener receptacles shall be clean and free of debris and obstruction

during installation of cover/grate fasteners.

3. Install funnel assembly (#3) onto leveling ring (#5) and secure with 4 (four) security screws (#2) with

screw driver security T25 (#15). Secure self-threading screws to 14 in-lbs on initial install and 10

in-lbs for subsequent insertions.

4. Install the cover (#1) onto the funnel assembly (#3) and secure with 3 (three) security screws (#2).

Secure self-threading screws to 34 in-lbs on initial install and 20 in-lbs for subsequent insertions.

5. After securing each SOFA component hand check that it is snug to the sump /frame before

proceeding to the next component.

MDX-R3 VINYL INSTALLATION

DO NOT USE POWER TOOLS TO INSTALL FASTENERS. Start

all fasteners by hand to prevent cross threading. Cover/grate when

installed shall not protrude more than 2" (51mm) from the finish surface

For technical assistance call 1.800.621.5886 or contact your regional representative