Bilisoft Cable Connector And Fiberoptic Lenses - GE BiliSoft Operation And Maintenance Manual

BiliSoft Cable Connector and Fiberoptic Lenses

CAUTION:
Never immerse the fiberoptic lenses in liquid.
CAUTION:
Do not autoclave or gas sterilize the fiberoptic light pad, fiberoptic cable or
fiberoptic cable connector.
CAUTION:
Exposing the light input end of the fiberoptic cable connector to strong
cleaning solutions, alcohol, or ultraviolet light can cause premature breakdown
of the fiberoptic lenses. Cleaning solutions that discolor the lenses, such as
iodine solutions, will reduce the pad's light output. Do not place the fiberoptic
cable connector in direct sunlight. Do not use iodine solutions, strong acids,
strong alkali, or bleach solutions to clean the fiberoptic cable connector.
Clean the fiberoptic cable connector using a mild detergent
solution. Never use an abrasive cleaner on the fiberoptic
cable connector. If disinfection is required, aqueous
solutions, which are both hospital disinfectants and
microbactericides, may be used sparingly, minimizing their
exposure to the fiberoptic lenses. Apply the cleaning
solutions with a clean soft cloth. Do not saturate. Remove
any cleaning residue from the fiberoptic lenses with a clean
damp soft cloth soaked with water only. Do not spray
cleaner directly on the fiberoptic cable connector (see
illustration, right). See table on this page for a list of approved
cleaners.
The following table lists approved disinfecting solutions (minimize exposure to fiberoptic lenses):
WARNING:
Never use flammable solutions to treat the BiliSoft LED Phototherapy System
or any of its parts.
Generic
Formulation
Hydrogen
peroxide
Sodium
hypochlorite
Cavicide
®
7-4
Maximum concentration level
6%
100 parts per million (ppm)
100% spray (sprayed on cloth – not directly on equipment)
M1110147 Rev. 5 © 2007 Datex-Ohmeda. All rights reserved.