Related Manuals for Clarke CTC150LI
Summary of Contents for Clarke CTC150LI
- Page 1 12V CORDLESS TYRE INFLATOR MODEL NO: CTC150LI PART NO: 7640300 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0921...
- Page 2 INTRODUCTION Thank you for purchasing this CLARKE Tyre Inflator. The CTC150Li can be used for inflating car, motorcycle and bicycle tyres, inflatable sports balls and other inflatables. The compressor is not waterproof and should not be used in any wet applications.
-
Page 3: General Safety Warnings
3. NEVER over-reach. Keep your proper footing and balance at all times to enable better control of the tyre inflator in unexpected situations. 4. NEVER attempt any complex repairs yourself. If you have a technical problem contact your local CLARKE dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 4 Arrange repairs with your CLARKE dealer. 6. BEFORE USE CHECK THE TYRE INFLATOR AND HOSE FOR DAMAGE: NEVER use the tyre inflator if it is damaged. Have it repaired by your CLARKE dealer. DO NOT use if the On/Off switch does not operate correctly.
- Page 5 OVERVIEW UNPACKING After removing the tyre inflator from its packaging, check that it has not been damaged in transit. Report any damage immediately to the CLARKE dealer where the item was purchased. ADAPTORS Clipped to the top of the tyre inflator or are three adaptors for different uses.
-
Page 6: Working Conditions
WORKING CONDITIONS 1. DO NOT use the tyre inflator in a damp or wet environment. The compressor should only be used with good ventilation. There should be no dust, acids, vapour, explosive or flammable gases in the room. 2. DO NOT cover the tyre inflator. Always position it with good all-round air ventilation and that the air intake air is dry and dust free. - Page 7 USING THE TYRE INFLATOR 1. Always inspect the tyre inflator before use to ensure the high pressure hose is in good condition. 2. Connect the air hose to the tyre inflator by screwing the hose into the end of the tyre inflator. 3.
-
Page 8: Tyre Inflation
• For continuous inflation you can push the switch lock upwards to lock while the On/Off trigger is depressed. In this way, inflation continues without pressing any button. To stop, simply squeeze the trigger to release the locking switch. NOTE: Note that the tyre inflator has a 10 minute running/10 minutes resting duty cycle. -
Page 9: Maintenance
Ensure that no water can get into the interior of the tyre inflator Your CLARKE tyre inflator has been designed to give long and trouble free service. If, however, having followed the instructions in this booklet carefully, you encounter problems, take the tyre inflator to your local CLARKE dealer. -
Page 10: Component Parts
Operating switch GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...