Fig.10 Changing The Fl Uorescent Lamp In The Cabinet; Fig.11 Changing The Fl Uorescent Lamp Of The Upper Panel - Igloo EWA 500.P User Manual

Fig. 10 Changing the fl uorescent lamp within the cabinet
1 – Starter of the fl uorescent lamp
2 – Base profi le
3 – Casings of the fl uorescent lamp and the starter
4 – Fluorescent lamp
5 – Transparent casing of the fl uorescent lamp
1 2
Fig. 11 Changing the fl uorescent lamp of the upper panel
1 – Plexi plate of the upper panel
2 – Grips fi xing the Plexi plate
3 – Grip of the fl uorescent lamp
4 – Fluorescent lamp
5 – Metal screw
6 – Hole plug of the upper panel
7 – Casing of the fl uorescent lamp and the starter
8 – Starter of the fl uorescent lamp
9 – Casing of the fl uorescent lamp
Door seal should be cleaned only with clean water, without addition of washing agents, and it should be
thoroughly dried. The seal cannot come in contact with greasy substances or oils!
During maintenance services it is necessary to check whether doors close in a proper manner.
Test: place a sheet of paper between the seal and the casing and close the door. The paper
should pose felt resistance during an attempt of pulling it out
During maintenance services it is necessary to pay attention not to damage the data plate of the device,
which contains signifi cant information for servicing organs and waste removal companies.
20
User manual Medium-freezing and freezing cabinets
2
5
4
3 4
9
1
2
3
4
5
5
8
en
6
7
1
www.igloo.pl