Point Copy; Prog Outputs; Programming Nacs - Bosch D7024 Operation And Installation Manual

Hide thumbs Also See for D7024:
Table of Contents

Advertisement

7.4.3

Point Copy

Shortcut:
0-PROG > 4-PROG INPUTS > 3-POINT COPY
This feature copies the settings you entered for one
point to one or more other points.
The following window appears:
COPY FROM
POINT:_ _ _
1.
Enter the point you want to copy from and press
[#].
COPY TO FIRST
POINT:_ _ _
2. Enter the first point you want to copy to and press
[#].
COPY TO LAST
POINT:_ _ _
3. Enter the last point you want to copy to and press
[#].
The PROG INPUTS Menu appears.
This feature does not copy the description. Point copy is
only intended for use on input points. Do not copy from
an output point (future use) or copy over a programmed
output point. The copy operation automatically stops,
with an error message, if outputs are encountered.
While copying to a large number of points, the remote
keypads might briefly display SYSTEM FAULT because
they are not updated during the copy operation.
7.5

PROG Outputs

PROG OUTPUTS
1- NACs
2- RELAYS
7.5. 1

Programming NACs

Shortcut:
0-PROG > 5-PROG OUTPUTS > 1-NACs
Bosch | 7/05 | 31499J
D7024 | Operation and Installation Guide | 7.0 Control Panel Programming
The main panel includes two local NACs, NAC 1 and
NAC 2. The D7024 can also support up to two D7038
Remote NAC Power Supplies offering a total of eight
remote NACs, for NACs for each RNAC.
The following window appears:
Press the number key corresponding to your selection.
Local NACs
Shortcut:
0-PROG > 5-PROG OUTPUTS > 1-NACs
The display scrolls through the NAC options.
1.
Press [1] for LOCAL to access:
Onboard NAC 3, NAC 4 are not currently supported.
2. Press the number key corresponding to your
selection.
The display scrolls through the following:
3. Press the number key corresponding to your
selection.
When [2] is selected from the PROG NACs Menu,
the following selections scroll:
NAC OUTPUTS
1- LOCAL
2- REMOTE 1
3- REMOTE 2
ONBOARD NAC
1- NAC #1
2- NAC #2
3- NAC #3
4- NAC #4
PROG NAC
4- (reserved)
5- CONFIGURATION
6- ZONE ASSIGNS
NAC CONFIG ()
1- STEADY
2- PULSING
3- TEMPORAL
4- WHEELOCK
5- GENTEX
45

Advertisement

Table of Contents
loading

Table of Contents