Display Current Address (Starting With Lowest Address Digit); Set New Address (Starting With Lowest Address Digit); Examples - Regin RDAS-24C Series Manual

3.3.1

Display current address (starting with lowest address digit)

Colours
Red
Green
Orange
Example for address 124:
LED
N N o o t t e e ! ! The address is entered and shown starting with lowest address digit, see figure above (124 in
the example is starting with 4x red)
3.3.2

Set new address (starting with lowest address digit)

1. Enter addressing mode: press and hold the button for longer than 1 second until LED shines red, then
release button (before LED gets dark).
2. Enter digits: press the button n-times ->LED flashes per button press (feedback).
Colours: 1-digits: red / 10-digits: green / 100-digits: orange
3. Store digits: press and hold button until LED shines in colour of next digits -> release button.
4. Save address: press and hold button until LED shines red (confirmation) -> release button.
An address can be stored at any time, i.e. after setting the 1-digits, or after setting the 1- and the 10-
digits.
5. Entered address is repeated one times for confirmation.
N N o o t t e e ! ! If button is released before LED shines red, the address is discarded.
3.3.3

Examples

Set address "124":
1. Enter addressing mode: press and hold the button for longer than 1 second until LED shines red, then
release button (before LED gets dark).
2. Set 1-digits: Press button 4-times -> LED flashes red per button press
3. Store 1-digits: Press and hold the button until LED shines green - release button
4. Set 10-digits: Press button 2-times -> LED flashes green per button press
5. Store 10-digits: Press button until LED shines orange - release button
6. Set 100-digits: Press button 1-times -> LED flashes orange per button press
7. Store address: Press button until LED shines red - release button
-> address is stored and displayed 1 time for confirmation
RDAS...-24C variable list, Rev. A
Digits
1-digits
10-digits
100-digits
4
Modbus
2 1
11