Assembly Instructions; Step 1; Step 2 - FRAME IT ALL Stack & Extend VEGGIE WALL Assembly Instructions

ASSEMBLY INSTRUCTIONS

STEP 1:

Screw the short upper tube
Screw lower tube
complete one upright pole. Repeat to build the other two upright poles.

STEP 2:

Place T-connector
connect the two horizontal poles, join T-connector
4
L-connector to produce the corner hinge. Place the two ends of
horizontal pole
10
Place this assembly onto ground to attach the cross brace
sure the open connector holes are facing down. Position cross brace
over the pre-drilled holes on both horizontal tubes
Connect brace
11
through the cross brace and pre-drilled holes in the tubes, then bend
the pins to create snug fit.
Place the adapter cap
STEP 2
6
10
5
9
into the middle tube
7
into the connected tubes
5
into one end of each horizontal tube
without connectors into this connection hinge.
onto horizontal tube
on each connection point.
6
3
4
11
Customer Service: 1800-914-9835 | support@frameitall.com
8
and tighten.
8
and
5
and
.
10
by pushing the cotter pin
10
6
3
5
10
9
, tighten to
. To
10
11
. Make
11
3
6
4
5
STEP 1
9
8
7