FRAME IT ALL Stack & Extend VEGGIE WALL Assembly Instructions

Advertisement

KIT CONTAINS:
**Use Stake
if you install
Stake
veggie wall
x 3
directly in the
ground
1
Lower
Middle
Tube
Tube
x 3
x 3
8
7
*RAISED BED
NOT INCLUDED
Sold Separately
Adapter Caps
Cotter Pin x 2
x 3
2
Long Tube x 2
10
Upper
Tube x 3
11
9
Customer Service: 1800-914-9835 | support@frameitall.com
© Frame It All. All Rights Reserved.
VEGGIE WALL
Stack &
Each kit will include 2 x 4'
curved panels, frame,
netting and all connectors
**Extendable – combine 2 kits
to expand to any dimension,
requires 2 kits of more
L Connector
x 2
3
Cross Brace x 1
300001252-C
Extend
**
- Used with *curved raised bed
T Connector
x 3
4
5
Net x 1
12
Cap x 3
6
Tie
x 28
13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stack & Extend VEGGIE WALL and is the answer not in the manual?

Questions and answers

Summary of Contents for FRAME IT ALL Stack & Extend VEGGIE WALL

  • Page 1 Cotter Pin x 2 L Connector ground x 28 Long Tube x 2 Lower Middle Upper Tube Tube Tube x 3 Net x 1 Cross Brace x 1 Customer Service: 1800-914-9835 | support@frameitall.com © Frame It All. All Rights Reserved.
  • Page 2 ASSEMBLY INSTRUCTIONS STEP 1: STEP 1 Screw the short upper tube into the middle tube and tighten. Screw lower tube into the connected tubes , tighten to complete one upright pole. Repeat to build the other two upright poles. STEP 2: Place T-connector into one end of each horizontal tube .
  • Page 3 ASSEMBLY INSTRUCTIONS STEP 3: STEP 3 Take the entire assembled top frame and insert on top of the 3 vertical poles. If you are placing this into an already built raised garden utilize the stake cover hole and slide the vertical poles through the stake cover into the stake (see STEP 4 Image) STEP 4 STEP 4:...

This manual is also suitable for:

300001252-c

Table of Contents