Adaptation Of The Adapter On The Wheelchair - Proactive NJ1 Assembly Instructions Manual

Usage instructions Adapter & Adaptation
Clamp
M6 fixing screws
Figure 9: M6 positioning screws to horizontally posi-
tion the centring column mount
Ensure that the locking plate and centring
column mount align precisely.
The items delivered include spacers which
can be assembled as required between the
locking plate and fixing rail as well as in the
correct number between the central column
holder and terminal clamp. The distance that
the wheelchair steering wheels are lifted off the
floor on the adapted product can be modified
by the assembly / removal of several spacers.
When fitting spacers, it may be necessary to
use a longer M8 fixing screw (Metric size
6 mm). Make sure that the screw-in depth is at
least 12 mm and the fixing screw is not resting
on the adapter tube.
Before you now adapt the adapter to the
wheelchair, check (this is usually pre-installed
by the factory) whether the two centring pins
on the locking plate are mounted correctly for
the size of the central part of the folding
mechanism on the wheelchair (two sizes pos-
sible). To do so, compare the perforation dis-
tance on the folding mechanism with the dis-
tance of the centring pins. If the positioning is
incorrect, you can modify the centring pin posi-
tion by loosening the M5 fixing screws (Metric
size 3 mm). After repositioning the fixing
screws tighten with 4 Nm.
Figure 10: Centring pins assembled for wide centre
part
Figure 11: Centring pins assembled for narrow cen-
tre part
4.3 Adaptation of the adapter on the
wheelchair
Before adapting the wheelchair, the clamp
levers must be released inwards and the lock-
ing heads must be placed in the vertical posi-
tion.
Locking heads opened
Clamp levers released
Figure 12: Locking heads in open (vertical) position
and clamp levers released
6