Detaching The Adapter From The Product - Proactive NJ1 Assembly Instructions Manual

Figure 91: Adapter head completely positioned on
the docking plate
The eccentric clamp lever must then be
pressed to clamp (upwards). Finally the secur-
ing bolt must be inserted until the locking
sphere of the securing bolt is locked in the
drive direction to the right outside of the dock-
ing plate or the right outer side of the docking
plate is visible. Only in this position may the
product be operated on the wheelchair.
Securing bolt inserted
Figure 92: Adapter is adapted and ready for opera-
tion
Locking sphere
Figure 93: Securing bolt with locking sphere, locking
sphere locked on the right outer side of the docking
plate
27
Eccentric
clamp lever
pushed to
"clamp"
Usage instructions Adapter & Adaptation
Before setting off the parking stands must still
be moved from the active to the passive posi-
tion and the wheelchair's parking brake re-
leased.
Note: You can watch a video on how to adjust
the adapter to the wheelchair on YouTube:
https://www.youtube.com/watch?v=lNL
QGXC3g0E
9.3 Detaching the adapter from the
product
First, apply the parking brakes on your wheel-
chair. If you do not have the option to apply the
parking brake, e.g. by using a wheelbase ex-
tension, move your wheelchair backwards
against a wall.
Then move the product's parking stands to the
active position.
The securing bolt is now pulled out completely
again to the outer stop, the pre-selection lever
grid mechanism is switched to "unlock" (upright
position) and the eccentric clamp lever is
turned to "loose".
Pre-selection lever grid mechanism
is switched upwards to "unlock"
Securing bolt
removed
Figure 94: Preparation for detachment
Eccentric
clamp lever
to "loose"