Figure 75: Front adapter remaining on the product
with opened quick-snap mechanism
If the front adapter has to be removed from the
product, undo the carabiner hooks from the
lifting eyes and take the adapter off the prod-
uct.
8
FREEWAY: Adaptation on the
product and detachment from
product
The adaptation of the adapter on the product is
shown below using the central adapter. The
approach also applies to the front adapter.
8.1
Terminology
Here you will find an illustration of the terms
used in the following to make it easier for you
understand:
Pre-selection lever
Insertion shaft
grid mechanism
Eccentric
Mount for
clamp lever
safety bolts
Figure 76: Steering head terms
23
Usage instructions Adapter & Adaptation
Coupling
fittings
Carabiner
hooks in the
lifting eyes
Insertion
shaft of the
adapter on
the insertion
bolt of the
docking plate
Figure 77: Docking plate terms
8.2
For adaptation, the pre-selection level click
mechanism on the steering head must be set
to "lock" (flat) and the eccentric clamp lever to
"loose" (upper neutral setting for grid). The
securing bolt is not inserted or if there is a
securing bolt with a nut this is pulled out to the
fullest extent.
Figure 78: Adapter settings at the start of adaptation
For adaptation, the insertion bolt of the docking
plate must be inserted into the insertion shaft
on the steering head.
Insertion bolt
Securing bolt
Adaptation on the product
Pre-selection grid mechanism to "lock"
Eccentric clamp lever to "loose"