NJ1 e-assistant usage instructions Contents 1 Preface ............................... 4 2 Legend ..............................4 3 Conformity/other information ......................4 3.1 Classification ..........................4 3.2 Conformity........................... 4 3.3 Manufacturer ..........................4 4 Scope of delivery and testing the product on receipt ................. 4 5 Introduction ............................
Page 3
NJ1 e-assistant usage instructions 20.1.2 Parking stand height adjustment ................. 15 20.2 Bottom bracket support and crank ................... 16 20.2.1 Seating position ......................16 20.2.2 Bottom bracket position ....................16 20.2.3 Crank length and grip width ..................18 20.3 Grips ............................18 20.4 Gear shift ..........................
Page 4
NJ1 e-assistant usage instructions 29 Liability .............................. 33 30 Appendix: Tightening torques and securing details ................. 34 31 Appendix: Medical product passport/record of training ..............35 32 Appendix: Hand-over certificate ....................... 36 32.1 Required compliance criteria to authorise use ................. 36 32.2 Check list for training the user ....................
Conformity/other information Dear Customer, Classification Congratulations on purchasing your new The NJ1 e-assistant (referred to as a "product" PRO ACTIV product. You have bought a quali- below) is classified as a class I product. ty product that has been specially customised Conformity to meet your requirements.
NJ1 e-assistant usage instructions However, please check the product immediate- It is then vital that the advice from doc- ly upon receipt, preferably in the presence of tors, therapists and the rehabilitation specialist the freight company, for any damage which dealer on the necessary safety accessories may have occurred in transit.
NJ1 e-assistant usage instructions have been trained in its use by the rehabili- The product may be used only in conjunc- tation specialist dealer or PRO ACTIV. tion with the approved adapter. Weight limita- tions must be observed while doing so. The...
NJ1 e-assistant usage instructions Recommended equipment: temperature of 20°C, constant speed, optimal The wheelchair can be equipped with an anti- tyre pressure, no headwind, etc.), and a user roll back device that can be activated before weight of approx. 85 kg, the following ranges driving on slopes.
NJ1 e-assistant usage instructions (e.g. slippery ground when wet), the drive its settings. Therefore, you should observe the wheel may start to spin before the maximum values given in the wheelchair's usage instruc- climbing power has been reached. tions or the restrictions dependent on the set- tings.
NJ1 e-assistant usage instructions When contacting your rehabilitation specialist recommended that you take along an assistant dealer or PRO ACTIV with regard to your to the training so that, if required, they can product, please always have the serial number assist you later when handling the product.
NJ1 e-assistant usage instructions Before every trip, check the condition of Check the function of the front and rear the wheels of the wheelchair-product combina- lights as well as the effectiveness of the side tion (e.g. visual inspection of the spokes and and rear reflectors before every trip.
Page 12
NJ1 e-assistant usage instructions Always hold onto the crank handles with At twilight and in the dark and in bad light- both hands while driving, braking, and ing and weather conditions, always switch on manoeuvring. If a driving situation requires you...
NJ1 e-assistant usage instructions Brake the product using the service When driving over or passing obstacles, it brakes, and when driving down longer slopes, is important that you avoid any product or body activate the recuperation to relieve the brakes.
NJ1 e-assistant usage instructions 17 Safety instructions – after When driving in a curve or turning on hills driving/use or downward slopes, there may be an in- creased tendency to tip over to the side due to the changes in the centre of gravity. Avoid Always turn off the drive system immedi- such driving manoeuvres.
NJ1 e-assistant usage instructions To check or correct the tyre pressure, pro- Clamp lever ceed as follows: 1. Secure the product to prevent it rolling away. 2. The drive wheel is normally fitted with a car tyre valve. Unscrew the valve cap.
NJ1 e-assistant usage instructions to max. 1 cm larger. In this case, the product can be inserted into the adapter by tipping slightly to the rear (via the parking stand). Front of the towing attachment Dimension from the Figure 7: Parking stand in the active position...
NJ1 e-assistant usage instructions The following points must be fulfilled for the M6 oval head Adjustment inlet proper seating position: screw with with manoeuvring The cranks must not touch the knee or radius disc rollers thigh when they are being turned.
Page 18
NJ1 e-assistant usage instructions M6 clamp screws on M6 fixing screws on the bottom bracket the top fork bridge housing (height adjustment) M6 clamp screws on the clamp Figure 12: M6 fixing screws on the top fork bridge (angle adjustment)
NJ1 e-assistant usage instructions If you want to make a change to the bottom bracket position, please contact your rehabilita- tion specialist dealer or PRO ACTIV. Please note that, after a large adjustment to the chain bottom bracket position, the lines and the cable lengths must be adjusted.
Page 20
NJ1 e-assistant usage instructions On an electronic Di2 gearshift, gear changes Cassette are achieved by: Pressing the small button with your thumb to shift up. Pressing the large button with your thumb to shift down. For shifting up to a...
NJ1 e-assistant usage instructions For shifting up to a higher gear Slotted screw For shifting down to a lower gear Figure 24: Slotted screw to lubricate Figure 22: Chin operation via buttons For more information on derailleur gear sys- tems, please see the instructions provided by the gear manufacturer.
NJ1 e-assistant usage instructions 20.5.1 Disc and rim brakes Setting screw The brakes are operated manually using the on the brake brake lever. lever Figure 27: Setting screw on the brake lever Brake lever You can find further information in the brake Figure 26: Brake lever manufacturer's instructions.
NJ1 e-assistant usage instructions Activating the Deactivating the crank release crank release function function Figure 29: Parking brake via locking lever Figure 30: Left- and right-hand pressure plates 20.5.3 PRO ACTIV back-pedalling brake & Before every trip, test the brakes by mov-...
NJ1 e-assistant usage instructions 20.6 Rechargeable battery pack The charger may only be used under dry conditions. Protect it from rain and humidity, 20.6.1 General instructions fire and high temperatures. Avoid temperature Please refer to the accompanying documenta- fluctuations that can cause condensation.
NJ1 e-assistant usage instructions Figure 33: Socket bracket on the steering column with marking “R” for the right rechargeable battery and “L” for the left rechargeable battery (seen from above) Figure 35: Left rechargeable battery connected; magnetic connector in “L” socket...
NJ1 e-assistant usage instructions 20.7.1 Switching on and off To switch on the drive system, briefly press ON/OFF button on the middle button (rhombus ) on the controller. up / upper arrow button Figure 37: On and off button on the rechargeable...
NJ1 e-assistant usage instructions Display holder Actuation button for the front lights Figure 41: Actuation button for the front lights Figure 39: Display with display holder To remove the display, turn off the drive sys- tem and remove the display holder. To remove the display, turn the docked display by approx.
NJ1 e-assistant usage instructions To switch on the front lights, the rotary switch 20.9 Bell is turned to position “I”, to turn off, to position The bell can be actuated with the thumb or “0”. index finger without letting go of the handlebar.
NJ1 e-assistant usage instructions 21 Storage 18°C to 23°C and a humidity of 0 to 80 per- cent. The state of charge should be 70 per- Store the product on an easy-to-clean surface cent. in a dry environment, preferably at room tem- perature from +15°C to +25°C.
NJ1 e-assistant usage instructions When the product is in the transport vehicle, 23 Malfunctions you or the person accompanying you should In the event of malfunctions that cannot be proceed as follows: repaired by yourself based on the usage in- 1.
NJ1 e-assistant usage instructions The drive wheel should be regularly cleared of When maintaining the brakes, the gear- contamination. It is recommended that you use shift components, and the drive system, it is a soft sponge or a soft brush.
NJ1 e-assistant usage instructions 25.3 Proof of maintenance If you should discover any problems dur- ing these checks, please immediately contact To provide proof of the maintenance, you can your rehabilitation specialist dealer or use the inspection lists in Chapter 33. Always PRO ACTIV.
NJ1 e-assistant usage instructions According to the WEEE Directive, 28 Warranty electric and electronic devices PRO ACTIV guarantees that the product was must be disposed of in govern- free of any defects at the time it was handed ment-designated recycling facilities over.
NJ1 e-assistant usage instructions 29 Liability As the manufacturer of the product, PRO ACTIV is not responsible for its safety if: The product is handled improperly. The product is not maintained in accord- ance with the maintenance schedule laid down by PRO ACTIV.
NJ1 e-assistant usage instructions 30 Appendix: Tightening torques and securing details The following table shows the torques for shaft screws with a metric control thread (valid providing the drawing, assembly, or usage instructions do not state different values!): Tightening torque Ma in Nm depending on the screw strength Dimension Strength 8.8...
NJ1 e-assistant usage instructions 32 Appendix: Hand-over certificate 32.1 Required compliance criteria to authorise use Completed/ Topics Remarks fulfilled The product is suitable for the customer based on their own judgement and the customer information received regarding the disability-related restrictions.
NJ1 e-assistant usage instructions 32.2 Check list for training the user Completed/ Topics fulfilled Advised of the applicable legal regulations when driving on public roads. All mechanical function control elements were explained and their function demonstrated. Adaptation of the adapter to the wheelchair and removing the adapter from the wheelchair have been demonstrated and then performed by the user themselves and/or an assistant.
NJ1 e-assistant usage instructions 33 Appendix: Inspection lists Initial inspection: After 200 km or after 5 months Serial number: ____________________ not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated Functional and safety check of all lights (if fitted), steering and...
Page 40
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 41
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 42
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 43
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 44
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 45
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 46
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Page 47
NJ1 e-assistant usage instructions Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use Serial number: ____________________ OK / not OK resolved carried out Kilometre reading: ________________________ Check that all screws/fastening elements are firmly seated and...
Need help?
Do you have a question about the NJ1 e-assistant and is the answer not in the manual?
Questions and answers