Adaptation Of The Adapter On The Wheelchair - Proactive NJ1 Assembly Instructions Manual

Fixing rail with
thread holes
Figure 28: Positioning the clamping bracket in 15
mm steps
To position the centring column mount
horizontally, loosen the two M6 fixing screws
(Metric size 5 mm). You can now infinitely ad-
just the centring column mount along the
adapter tube. At the desired position, tighten
the fixing screws again with 7 Nm and secure
these with screw locking fluid.
Clamp
M6 fixing screws
Figure 29: M6 fixing screws to horizontally position
the centring column mount along the adapter tube
When adjusting settings, make sure that the
clamping bracket and centring column mount
are exactly aligned.
When the adapter is attached to the wheel-
chair, the centring column mount should have
around 1 mm play to the terminal clamp on the
centring column (Fig. 30).
11
Usage instructions Adapter & Adaptation
Centring column terminal clamp
Centring
column
mount
Figure 30: Centring column mount on the centring
column
The items delivered include spacers which
can be assembled as required between the
clamping bracket and fixing rail as well as be-
tween the centring column mount and terminal
clamp (fig. 26). The distance that the wheel-
chair steering wheels are lifted off the floor on
the adapted product can be modified by the
assembly / removal of several spacers. When
fitting spacers, it may be necessary to use a
longer M8 fixing screw (Metric size 5 mm).
Make sure that the screw-in depth is at least
12 mm and the fixing screw is not resting on
the adapter tube.
5.3 Adaptation of the adapter on the
wheelchair
Clamping bracket with clamp
levers and fixing hooks
Pull loop on
clamp levers
Figure 31: Adaptation elements on the adapter and
pull loop on the clamping bracket
First open the adapter's clamp lever by pulling
the pool loops forward in the direction of the
adapter's steering head. Then guide the cen-
tring column mount onto the centring column
on the back cross tube, and then past the fix-
ing hook of the clamping bracket after pushing
0.5-1 mm play
Centring column
mount