Maintenance; Periodic Inspection, Cleaning; Operating Sequence; Power Source Commands And Signals - Cebora PLASMA PROF 80 Service Manual

CEBORA S.p.A.

3 - MAINTENANCE

ANY INTERNAL INSPECTIONS OR REPAIRS MUST BE CARRIED OUT BY QUALIFIED
DISCONNECT THE POWER SOURCE FROM THE MAINS BEFORE PERFORMING

3.1 - Periodic inspection, cleaning.

Periodically remove dirt and dust from the internal parts of the power source, using a jet of
low-pressure dry compressed air or a brush.
Check the condition of the output terminals and the power source power cord; replace if
damaged.
Check the condition of the internal power connections and connectors on the electronic
boards; if you find "loose" connections, tighten or replace the connectors.

3.2 - Operating sequence.

The following sequence reflects correct machine operation. It may be used as a guiding
procedure for troubleshooting.
It must be carried out after each repair without any errors.
Operations preceded by this symbol refer to operator actions.
♦ Operations preceded by this symbol refer to machine responses that must occur following an
operator action.

3.2.1 - Power source commands and signals.

3.302.167
WARNINGS
PERSONNEL.
MAINTENANCE.
NOTE
6
25/06/04