Mercedes-Benz B-Class Owner's Manual page 361

358 Breakdown assistance
358
Pull plug 7 with the cable and ller hose
#
out of the tyre in ation compressor housing.
Insert tyre sealant bottle 9
#
the tyre in ation compressor in such a way
that the red arrow on tyre sealant bottle
matches the red arrow on the tyre in ation
compressor.
Turn tyre sealant bottle
#
clockwise.
Insert the plug of ller hose
#
of tyre sealant bottle 9.
Turn ller hose
#
3
Remove the valve cap from valve
#
faulty tyre.
in socket 6 of
Screw union nut
#
9 valve A.
Insert plug
#
cle.
Turn the key to position 1 in the ignition lock.
#
9 a quarter turn
3 in socket 5
3 a quarter turn clockwise.
A on the
4 of ller hose 3 onto
7 into a 12 V socket in your vehi-
Press on and o switch 8 on the tyre in a-
#
tion compressor.
The tyre in ation compressor is switched on.
The tyre is in ated. First, tyre sealant is pum-
ped into the tyre. The pressure may brie y rise
to approximately 500 kPa (5 bar/73 psi).
Do no Do not switc t switch h o o t t he tyr he tyre e in ation in ation com
dur during t ing this phase! his phase!
Let the tyre in ation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
a ected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, If, a er a er t t en minut en minutes, a tyr es, a tyre pr e pressur essure of 200 kPa
(2.0 bar/29 psi) has not been att (2.0 bar/29 psi) has no t been attained:
Switch o the tyre in ation compressor.
#
compr pressor essor
e of 200 kPa
ained: