Battery
cover
(2)
2.5mm AF
(1)
Screw
To replace exhausted battery - remove cover
1. Slacken screws (1) and remove battery
cover (2).
2. Remove battery (3).
Do not remove second cover, to change
battery.
Probe/shank mounting and stylus on-centre
adjustment - remove second cover
3. Remove screw (4) and battery cover (5).
- see page 19.
MP7 - 8 - 9 BATTERY COVERS and BATTERY
Label
Battery
Cover
seal
(4)
Screw
DO NOT leave exhausted battery in probe
Dispose of exhausted batteries in
(3)
accordance with local regulations
To replace battery covers
4. Check that battery cover seals are seated,
and lubricate seals lightly with a mineral oil
or grease.
5. Replace cover (5) - with Renishaw logo .
6. Replace battery with polarity as shown on label,
7. Replace battery cover (1) - with battery symbol .
Tighten battery cover screws to 1.1 Nm
(0.8 lbf.ft).
17
(5)
Battery
cover
IMPORTANT
Insert battery as
shown on label