Voxelab Proxima 6.0 Quick Start Manual page 12

Press
9.
If twitch a piece of A4 paper and feel the large resistance, press (not heavy) the tap
of the build plate with one hand to let four corners of build plate to touch the LCD
screen evenly. And just tighten lightly the screws in the front and right side of
cradle head first. Then tighten again. If twitch a piece of A4 paper and don't feel
the large resistance, tap [0.1mm] in the touched screen and twitch paper and feel
the resistance again. Repeat it, until feel the large resistance from paper. Then
tighten all screws.
Note: Because of change in tightness by tighten screws on the build plate, it have
to adjust the height of Z-axis. If twitch a piece of A4 paper and feel little
resistance or no resistance, tap [0.1mm] and the height of Z-axis decline 0.1mm.
If twitch a piece of A4 paper and feel large resistance, tap [0.1mm] and height of
Z-axis rise 0.1mm. Over and over. The perfect state is pulling out the paper and
you still feel some resistance.
0.1mm
10. Tap [Back] to come back and tap [Set Z=0] to set the height of the current
build plate to zero. Then tap [Manual] to lift the build plate upper.
Expect for the first time print, it also need leveling after replacement of build
plate and new screen；if there are some printing issues, like printed model can
not stick build plate, leveling operation may required to slove it.
Tighten the screws
1mm 10mm
Manual
Stop
10
Exposure Set Z=0
Back