Set-Up Procedures - Water Control Corporation SF Series Owner's Manual

Table of Contents

Inspect distributor assembly inside of each tank for damage. The distributor assembly is shipped secured to the resin tank, but damage can occur during

shipping. If the distributor is damaged, do not fill resin tank with gravel/media as it will need to be removed for distributor repair.

Contact WCC at 763-427-9638.

Unpackage the resin tanks and place them into/near their installation location. Leave the knockout plug on the distributor tube. This will be removed

after the gravel/media has been loaded into the resin tanks.

Load the gravel into the resin tanks using the supplied funnel. The funnel is shipped in the brine tank. See gravel chart for number of gravel bags per

tank.

Load the softening media into the resin tanks using the supplied funnel. The funnel is shipped in the brine tank. See chart for number of resin bags

to install per tank.

(3) O-rings will need to be installed onto the valve and resin tank flange adapter. (1) O-ring will be installed onto the control valve and (2) will be

installed onto the flange adapter. After installing the O-rings onto the flange adapter/control valve, silicone should be applied to the O-ring for ease

of installation.

Remove the knockout plug on the distributor tube.

Install the flange adapter onto the resin tank.

Install the control valve onto the flange adapter.

The water lines can now be connected to the control valve.

a. WCC recommends installing isolation valves on the inlet and outlet of

each control valve.

b. WCC recommends installing a full system bypass.

The drain lines can now be connected to the control valve.

a. Floor drain must be capable of handling full backwash flow rate

(see specs for backwash rate).

10.

Connect the power cords to the control valve and plug into GFI wall outlet.

a. Each control valve should have a dedicated 120V outlet.

11.

Contact WCC for startup instructions: (763) 427-9638.