Command center, boiling, chilled & sparkling (19 pages)
Summary of Contents for Zip HydroTap
Page 1
Grab an empty bucket or container to collect the water which will be flushed through the system and an old towel to mop up any spills. Step 2: Open the filter access door on the front of the HydroTap Command Centre. You will see the filter cartridge in front of you. Step 3: Reach to the rear right hand side of the cartridge and you’ll find a flush line (looks like a hose) which is around 60cm...
Page 2
Step 4: Gently hold the filter cartridge then press the red lever at the top right of the unit and rotate the cartridge a quarter turn to the left. The unit should detach and you should be able to pull it free in a downwards motion. Some water may drip from the cartridge at this point.
Page 3
Step 7: Slightly moisten the O-rings with regular tap water and line up the front cartridge label to the left. Step 8: Gently but firmly push the cartridge up into the filter head and turn a quarter-turn to the right – as far as it will go without forcing it.
Page 4
Step 9: Press the [MENU] button to bring up the main menu on the screen. Step 10: Press the [Install] button and turn the stop valve ON by rotating the lever clockwise until it is in line with the hose...
Page 5
Step 11: Press the [Filter Flush] button then press [Start] to begin the process. Ensure you run at least 10-litres of water through to flush the filter of excess black carbon particles.
Page 6
Step 12: When the filter flush is finished, turn the stock valve OFF by rotating the lever anti-clockwise until it is perpendicular to the hose. Step 13: Press [Stop] to end the filter flush process. Step 14: Press the [Home] button to return to the home screen.
Page 7
Note: If you are carrying out this flush after the HydroTap’s initial installation, the unit will go directly into calibration mode after the Filter Flush Mode is turned off. With any subsequent filter changes the system will automatically revert to the main menu.
Need help?
Do you have a question about the HydroTap and is the answer not in the manual?
Questions and answers