Test Modes; Factory Default; Display Options - PRESONUS FaderPort 16 Owner's Manual

10 Customizing Your FaderPort
10.3

Test Modes

10.3 Test Modes
Tests
Tune Tune Factory Tests Display Display
Faders Touch Default Contrast Brightness
Sensitivity
10.4

Factory Default

Factory
Tune Tune Factory Tests Display
Default
Faders Touch Default Contrast
Sensitivity
10.5

Display Options

Contrast
Display
Tune Tune Factory Tests Display Display Version:
Contrast
Faders Touch Default Contrast Brightness Build Rev:
Sensitivity Build Date:
Build Time:
Turn knob
Apply
to adjust
<- Back
contrast
Turn knob
Apply
to adjust Apply
<- Back
contrast
Your FaderPort is equipped with multiple test modes to verify
electrical functionality of all its components. Press the Select
Build D
Build Time
button below the Test screen to access these modes.
Mardi Turn LEDs
Gras on
• Mardi Gras. This test mode will cycle through all the LEDs and
Fader movements. Press the last Select button to exit.
Turn LEDs on. This test mode turns on all LEDs, allowing you to verify their
•
functionality. Press the Select button below "Turn LEDs off" to end the test.
Set LEDs (red, green, blue). These test modes allow you
•
to test the color functionality of the RGB LEDs.
Test Inputs. Use this mode to test the faders and encoders.
•
In the unlikely event that a firmware update fails, restoring your FaderPort to Factory
Default will allow you to restore your unit to its factory firmware version.
Dis
Br
Press the Select button below "Display Contrast" to set the contrast of the scribble
strip displays to your desired setting.
2.00
12913
Oc
21:59:26
Turn the Pan/Param encoder on the left until the desired setting has been reached.
Press the Select button below the Apply screen to set.
FaderPort™ Multichannel Production Controllers
Turn LEDs Set LEDs Set LEDs
off red green
Owner's Manual
Set LEDs Test Inputs
blue
Back
76