Toshiba nv Series Instruction Manual page 24

Chapter 2 Installation and Wiring
12
6F8C1509
Before installing or removing the module,
WARNING
make sure that the basic unit to which the
IS911 module is installed is turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product
WARNING
except the switches.
It may cause an electric shock.
Install it under an environment that
CAUTION
satisfies the product specifications.
When installing it under an environment that does not
satisfy the product operating temperature range, apply
forced cooling with cooling equipment.
Operating temperature range: 0 to 55C
Before installation or wiring, remove the
CAUTION
static electricity from your body.
The static electricity accumulated in the human body may
cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause malfunction or
accidents.
Do not perform wiring, insertion of the
CAUTION
TC-net I/O bus cable connector, or
installation, removal, or replacement of the
base unit while the power is on.
It may cause an electric shock or malfunction.
When installing the product to the base unit, be careful
not to snap or bend the TC-net I/O bus connector pins.
When installing the product to the basic
CAUTION
unit, do not break or bend the pins of the
TC-net I/O bus connector.
If it is difficult to insert the module to the
CAUTION
basic unit, remove it once and try again
rather than forcing it.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited