Accessories; Initial Operation - eisenblatter POLY-PTX 802 HT Original Instructions Manual

EN
Original instructions POLY-PTX

8. Accessories

Only use original Eisenblätter battery packs and
Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
8.1 Accessories power tools and cordless operated
power tools:
Art. No. Description
40205 Suction cover / dust extraction lid
40206 Protective cover incl. polycarbonate
ancillary cover
40006va Grinding belt roller 85 x 70 mm
40007 Spacer ring set
38663 Ball joint mount
42002 Expansion roller 90 x 100 mm
42001 Expansion roller 90 x 50 mm
42004 Eco Smart adapter 45 x 100 mm for
extra-wide rollers
8.2 Accessories cordless operated power tools:
Art. No. Description
50463 CAS battery 5,5 Ah
50473 CAS battery 8,0 Ah
50474 High-speed charging device
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Grinding and fleece sleeves
• Grinding wheels
• Round wire brushes
• Grinding belts
• Expansion rollers
• Polishing sleeves
• Polishing rings
• Polishing belts
• Auxiliary materials for polishing
• Cleaning wheels
• Accessories for pipe machining
Note: Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
22
802 HT / POLY-PTX AKKU HT
® ®
9.1
type plate match your power supply.
The red electronics signal indicator (A1-4) lights up
briefly when the mains plug is inserted in the socket,
indicating readiness for operation.
Setting speed:
The speed can be preset via the thumb-wheel (A1-9) and
is infinitely variable.
Positions 1-6 correspond approximately to the following
no-load speeds:
1
2
3
The VTC electronics make material-compatible work
possible and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
surroundings are heavily polluted.
and metal particles. The particulate matter protection cap
(A5) is recommended for fine dust.
Dust Prevent System:
To remove: See page 2, figure A3.
To remove the Dust Prevent System (A2-1), first remove
the locking screw on the bottom with a torque screw-
driver. Then you can slide the Dust Prevent System over
the cable and remove it upwards.
Attachment: Pull the Dust Prevent System (A2-1) over
the cable to the ventilation slots of the machine. Then fix
it with the locking screw on the bottom.

9. Initial operation

For mains powered machines only:
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
Always install an RCD with a maximum trip current
of 30 mA upstream.
820 min
-1
1,380 min
-1
1,760 min
-1
Always fit the Dust Prevent System (A2-1) or the
particulate matter protection cap (A5) if the
Recommendation: Use the Dust Prevent System
(A2-1) to protect your machine from coarse dust
4 2,260 min
-1
5 2,760 min
-1
6 3,000 min
-1
www.eisenblaetter.de