eisenblatter POLY-PTX 802 HT Original Instructions Manual page 19

• The workpiece must lay flat and be secured against
slipping, e.g. using clamps. Large workpieces must be
sufficiently supported.
• If accessories with threaded inserts are used, the end
of the spindle may not touch the base of the hole
on the sanding tool. Make sure that the thread in the
accessory is long enough to accommodate the full
length of the spindle.
• The thread in the accessory must match the thread
on the spindle. See chapter 7. Technical data for more
information on the spindle length and thread.
• Damaged, eccentric or vibrating tools must not be
used.
• A damaged or cracked side handle must be replaced.
Never operate a machine with a defective side handle.
• Only use the machine if the protective cover is in
place.
• Always guide the machine with both hands on the
handles provided.
5.7 Special safety instructions for mains powered
machines:
• Pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
• Before connecting the mains plug, make sure that the
machine is switched off.
• Use of a fixed extractor system is recommended.
• Always install an RCD with a maximum trip current of
30 mA upstream. If the power tool is shut down via the
RCD, it must be checked and cleaned. See chapter 13.
Maintenance.
5.8 Special safety instructions for cordless
machines:
• Remove the battery pack from the machine before
making any adjustments, changing tools, maintaining
or cleaning.
• Make sure that the tool is switched off before fitting
the battery pack.
Protect battery packs from water and moisture!
Do not expose battery packs to naked flame!
• Do not use faulty or deformed battery packs!
www.eisenblaetter.de
Original instructions POLY-PTX
• Do not open battery packs!
• Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak from
defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately with
plenty of water. If battery fluid leaks out and
comes into contact with your eyes, wash them with clean
water and seek medical attention immediately!
• If the machine is defective, remove the battery pack
from the machine.
Transport of li-ion battery packs:
The shipping of li-ion battery pack is subject to laws
related to the carriage of hazardous goods (UN 3480
and UN 3481). Inform yourself of the currently valid
specifications when shipping li-ion battery packs. If
necessary, consult your freight forwarder.
Only send the battery pack if the housing is intact and
no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-
circuiting (e.g. by protecting them with adhesive tape).
5.9 Reducing dust exposure:
Some of the dust created using this power tool
may contain chemicals known to cause cancer,
allergic reaction, respiratory disease, birth defects or
other reproductive harm. Some of these substances
include: lead (in paint containing lead), mineral dust
(from bricks, concrete etc.), additives used for wood
treatment (chromate, wood preservatives), some wood
types (such as oak or beech dust), metals, asbestos.
The risk from exposure to such substances will depend
on how long you or bystanders are being exposed.
Do not let particles enter the body.
Do the following to reduce exposure to these
substances:
• Ensure good ventilation of the workplace and wear
appropriate protective equipment, such as respirators
able to filter microscopically small particles.
• Observe the relevant guidelines for your material, staff,
application and place of application (e.g. occupation-
al health and safety regulations, disposal).
• Collect the generated particles at the source, avoid
deposits in the surrounding area.
• Use suitable accessories for special work (see
chapter 8.), thus less particles enter the environment
in an uncontrolled manner.
802 HT / POLY-PTX AKKU HT
® ®
EN
19