Accessories; Initial Operation - eisenblatter PTX COMPACT HT Original Instructions Manual

8. Accessories

Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
Art. no. Description
40406 Grinding belt roller
40407 Expansion roller
40093 Filter fabric for particulate matter
protection cap
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Grinding and fleece sleeves
• Grinding wheels
• Grinding belts
• Expansion rollers
• Polishing sleeves
• Polishing belts
• Auxiliary materials for polishing
• Cleaning wheels
• Accessories for pipe machining
Note: Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
www.eisenblaetter.de
Original instructions PTX COMPACT HT

9. Initial operation

Rotating additional handle:
See page 3, figure D.
The additional handle (A1-2) can be adjusted 5 times for
different working positions. To do this, open the grip piece
until the additional handle can be moved, turn it to the
desired position and then tighten the grip again.
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
type plate match your power supply.
Always install an RCD with a maximum trip current
of 30 mA upstream.
Setting speed:
The speed can be preset via the thumb-wheel (A2-4 / C)
and is infinitely variable.
(Small number= small speed;
high number = high speed)
1 800 min
-1
2 1,300 min
-1
3 1,700 min
-1
The VTC electronics make material-compatible work
possible and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
Particulate matter protection cap
Always fit the particulate matter protection cap
(A1-3) if the surroundings are heavily polluted.
Attachment: See page 3, figures E1 and E2.
Attach the particulate matter protection cap as shown
by pushing it over the cable on the back of the machine
and pressing it into place.
To remove: See page 3, figure E3.
Remove the particulate matter protection cap as shown.
It can be removed from the back of the machine with
light pressure.
EN
4 2,300 min
-1
5 2,700 min
-1
6 3,000 min
-1
17