Table of Contents
Advertisement
Installing the Device
2.1 Unpacking the Device
Note
This product contains a Lithium battery that is not replaceable by the operator or by
service personnel.
2.1
Unpacking the Device
When unpacking the device, do the following:
1.
2.
3.
IMPORTANT
If any item is missing or damaged, contact Siemens for assistance.
2.2
Cabling Recommendations
Siemens does not recommend the use of copper cabling of any length for critical,
real-time substation automation applications. All copper Ethernet ports on
RUGGEDCOM products include transient suppression circuitry to protect against
damage from electrical transients and conform with IEC 61850-3 and IEEE 1613 Class
1 standards. This means that during a transient electrical event, communications
errors or interruptions may occur, but recovery is automatic.
Siemens also does not recommend using copper Ethernet ports to interface with
devices in the field across distances that could produce high levels of ground
potential rise (i.e. greater than 2500 V), during line-to-ground fault conditions.
2.3
Mounting the Device
The RUGGEDCOM RS900GPF is designed for maximum mounting and display
flexibility. It can be equipped with adapters that allow it to be attached to a DIN rail
or panel.
IMPORTANT
Heat generated by the device is channeled outwards from the enclosure. As such, it
is recommended that 2.5 cm (1 in) of space be maintained on all open sides of the
device to allow for some convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a
reduction of ambient temperature and improve the long-term reliability of all
equipment mounted in the rack space.
6
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
RUGGEDCOM RS900GPF
Installation Manual, 01/2021, C79000-G8976-1353-05
Advertisement
Table of Contents
