Before Initial Use; Setting Up And Connecting The Device - Beem BH9090 Manual

17
NOTICE – Risk of Damage to Material and Property
• The device should only be used if it has been correctly assembled! Check before each use
whether the collecting container and the lid have been placed on correctly and whether the
coffee roaster is fi lled correctly (note the MAX marking)!
• Switch off the device and pull the mains plug out of the plug socket if an error occurs during
operation, when there is a power cut or before a thunderstorm.
• Never pull or carry the device by the connecting cable. When you pull it out of the plug socket,
always pull on the mains plug and never the mains cable!
• Do not carry the device by the handle of the collecting container. The collecting container is
not securely fi xed on the device.
• Protect the device from heat sources, naked fl ames, sub-zero temperatures, persistent moisture
and impacts.
• Use only original accessories from the manufacturer in order to guarantee that there is no
interference that may prevent the device from working and to avoid possible damage.

Before Initial Use

Before the fi rst proper roasting process, we recommend that you carry out a trial run without
coffee beans in the MED programme (5) to remove any possible production residues. To do
this, follow the instructions in the "Setting Up and Connecting the Device" and "Roasting Coffee"
chapters.
When the device is fi rst used, production-related additives (e. g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.

Setting Up and Connecting the Device

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket must
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
• Do not connect the device along with other consumers (with a high wattage) to a multiple
socket in order to prevent overloading and a possible short circuit (fi re).
• Do not use the device in conjunction with extension cables.
• Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
04202_Inlay_DE-EN-FR-ES-IT_A5.indb 17 04202_Inlay_DE-EN-FR-ES-IT_A5.indb 17
EN
16.04.2021 11:48:26 16.04.2021 11:48:26