Before Initial Use - Beem S3.8.4 Manual

23
WARNING – Danger of Fire
• Do not use the device in rooms containing easily ignitable dust or poisonous and explosive
fumes.
• Do not connect the device along with other consumers (with a high wattage) to a multiple
socket in order to prevent overloading and a possible short circuit (fi re).
• Do not operate the device in the vicinity of combustible material. Do not place any combus-
tible materials (e.g. cardboard, paper, wood or plastic) in or on the device.
• Do not cover the device during operation.
• In the event of a fi re: Do not extinguish with water! Smother the fl ames with a fi reproof blanket
or a suitable fi re extinguisher.
NOTICE – Risk of Damage to Material and Property
• The device should only be used if it has been correctly assembled! Before each use, check
whether the lid is placed on correctly, the lever of the discharge tap is in the correct position
and the water reservoir is fi lled correctly!
• Lay the connecting cable in such a way that it does not become squashed or bent and does
not come into contact with hot surfaces (also applies to the hot surfaces of the device!).
• Switch off the device and pull the mains plug out of the plug socket if an error occurs during
operation, when there is a power cut or before a thunderstorm.
• Never pull or carry the device by the connecting cable. When you pull it out of the plug socket,
always pull on the mains plug and never the mains cable!
• Protect the device from other heat sources, naked fl ames, sub-zero temperatures, persistent
moisture, wet conditions and impacts.
• Use only original accessories from the manufacturer in order to guarantee that there is no
interference that may prevent the device from working and to avoid possible damage.

Before Initial Use

1. Set up and connect the device (see the "Setting Up and Connecting the Device" chapter).
2. Before you fi rst enjoy tea or hot instant beverages, we recommend that you carry out a trial
run to remove any possible production residues. To do this, follow the instructions in the "Op-
eration" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.
3. Perform this process twice if necessary. Do not drink this water!
4. Clean the device and accessories (see the "Cleaning and Care" chapter).
07204_DE-EN-FR-ES-IT_A5_V3.indb 23 07204_DE-EN-FR-ES-IT_A5_V3.indb 23
EN
08.02.2021 11:43:09 08.02.2021 11:43:09