Furuno MU-200 Operator's Manual page 29

12. Connect all connectors on the CONE Board (10P6877).
Pass cable from
J8,J9 through
clamp.
Pass cable from
J6 through
clamp.
Pass cable from
J7 through
clamp.
13. Fix the cable marked with a white arrow in the figure below with the clamp. Connect the
power connector (marked with gray arrow) to J1 on the pcb 10P3879: 1, Brown; 3,
Orange; 4, Purple, 6, White.
J9
J10 J11
J8
J6
J7
CONE Board (10P6877)
Display unit, rear view
AP-9
J5
J13
Pass cable from
J13 through
clamp.