Furuno MU-200 Operator's Manual page 13

Connecting FCV-1200 series
Using the cables designated below (or equivalent) to connect the FCV-1200 series makes
the interface unit of the FCV-1200 series unnecessary. The mini D-SUB 15 P connector
cannot be used to connect the FCV-1200 series.
100 - 240 VAC
Ground
Terminal
Notes on wiring
The cover of the D-SUB connector of the cable 06S4078 may be removed to pass the
cable through tubing, bulkhead, etc. Use vinyl tape to bind connector wiring and rubber
cover. This allows the cable to be passed through a hole having a diameter of 30 mm.
Attach connector SRCN6A13-3S (supplied in installation materials) to the power cable
(cable DPYC-1.5 (Japan Industrial Standard) or equivalent).
2 cm
Sheath
Armor
Armor
Armor
Attaching connector SRCN6A13-3S
How to attach connector SRCN6A13-3S; sectional view of power cable DPYC-1.5
Display unit, rear view, wiring using specialty cables
Screw
Tighten
Clamp
set screw
Connector Housing
Cable type
06S4078
Cable type
MJ-A10SPF0002-015
Solder Side
1 2
3
Connect to
"1" and "2".
1: AC (L: Live line)
2: AC(N: Neutral line)
5
Navigator
FCV-1200 Series:
PROCESSOR UNIT CN1
FCV-1200 Series:
CONTROL UNIT CONT
Vinyl
sheath
Armor
Conductor
S = 1.5 mm
B
Sectional view of cable DPYC-1.5
2
= 1.56 mm