Remote Controller Setting - Furuno MU-120C Operator's Manual

3.4 Remote Controller Setting

A remote controller can be set to be operative with a specific display unit, in the case of
multiple MU-120C display units. Set the remote controller mode desired on the SYSTEM
menu as follows;
1. Press the [MENU] key to show the main menu.
2. Press the [►] key to select SYSTEM.
Display
RGB1 RGB2 PVI VIDEO1 VIDEO2 VIDEO3 OSD
unit ID
INFRARED REMOTE
DEFAULT RESET
INFORMATION
RGB1 : RESOLUTION: 1280x1024 fH: 80KHZ fV: 75HZ
RGB2 : RESOLUTION: 640x480 fH: 31KHZ fV: 60HZ
DVI
VIDEO1: NTSC
VIDEO2: PAL
VIDEO3: NO SIGNAL
PROGRAM NO.:**********
3. Select INFRARED REMOTE.
4. Point the remote controller toward the display unit, and press any key on the remote
controller. The current setting of remote controller is shown inside the remote controller
setting square.
5. Press the [RGB2] and [BRILL +] keys together on the remote controller to change the
remote controller ID among A, B, C and D.
Your selection appears inside the square.
6. Press the [◄] or [►] key so that the display unit ID is the same as the remote controller
ID in the square.
7. Press the [MENU] key to close the menu.
A
NO
: NO SIGNAL
SYSTEM menu
12
Remote controller ID square