Setting Input/Output - Furuno RD-30 Installation Manual

2.3

Setting Input/Output

The I/O SETUP menu sets up the IN/OUT and AUX ports on the RD-30.
Additionally you can use this menu to output power to other display units,
in case of multiple display units.
Note: Note that the equipment can process data input at the rate of up to
430 characters/second. Some delay will occur when processing data
input at a higher rate.
1. Press the [MENU] key once or twice to open the main menu.
2. Select I/O SETUP and then press the [ENT] key.
3. Select IN/OUT PORT, AUX PORT or POWER OUT as appropriate and
then press the [ENT] key. One of the following displays appears
depending on your selection.
IN/OUT and
OFF
AUX options
IN/OUT
AUX
BOTH
OFF: No output
IN/OUT: Output data which is input through the IN/OUT port.
AUX: Output data which is input through the AUX port.
BOTH: Output mixed data which is input through the IN/OUT and AUX ports.
Figure 2-2 IN/OUT PORT, AUX PORT and POWER OUT options
Note: If, when BOTH is selected, the data sentence which has an
4. Select appropriate option and then press the [ENT] key.
5. When OFF, IN/OUT or AUX is selected for the IN/OUT or AUX port, go
to step 8.
When "BOTH" is selected for IN/OUT or AUX port, select IN/OUT
PORT or AUX PORT of the SELECT SENTENCE and then press the
[ENT] key.
I/O PORT SETUP
IN/OUT PORT :
AUX PORT
POWER OUT : OFF
< SELECT SENTENCE >
IN/OUT PORT
AUX PORT
Figure 2-1 I/O PORT SETUP menu
OFF
ON
OFF: No output
ON: Outputs power to other display units
input interval faster than one second (ROT, HDT, etc.) is turned
on, some data may not be output.
OFF
: OFF
POWER OUT
options
9