Timeguard MLTP180BK Installation & Operating Instructions Manual page 5

5.5 Undo the 4 fixing screws and remove
the PIR sensor from the back box
(See image 4).
5.6 Mark the position of the mounting holes on the wall using the back box
as a template (See image 5). Drill the holes ensuring not to infringe with any
gas/water pipes or electrical cables that may be hidden below the surface.
Insert the rawl plugs into the holes.
4
5.7 Pass the 230V 50Hz supply and load cables through the cable entry points
on the back box, ensuring the grommets are used to maintain the IP rating
of the PIR sensor (See image 6).
4
5
6