Fitting The Cover Strips - Viessmann VITOCELL 100-E Installation And Service Instructions Manual

Fitting the Vitotrans and thermal insulation,...

Fitting the cover strips

3.
2.
4.
Fig. 18
Type plate (self-adhesive)
A
1. Tighten the nuts on the bolts.
2. Trim and fit the cover strip.
3. Push in the rear thermal insulation of the Vitotrans.
Observe the groove in the thermal insulation.
4. Fit the front thermal insulation of the Vitotrans.
7.
6.
1.
(cont.)
A
5.
5. Tap the cylinder thermal insulation towards the
front. This reduces the gap between the Vitotrans
and the cylinder.
6. Fit the rear strip to the thermal insulation.
7. Affix the type plate.
Installation sequence
21