Table of Contents
Advertisement
PAN301x Bluetooth Module
Time of Flight (ToF) Sensor (PAN3013)
It is recommended to use a cover window with the dimension of maximum 12 mm × 8.5 mm.
It provides physical protection for the sensor, including protection for the dust ingress and it
provides optical filtering for the sensor.
The ToF sensor maker ST recommends a Hornix cover window ("IR-T042C0-PM3D-A066") as
an example of a very low crosstalk cover window.
However, the final cover window selection depends on the individual customer requirements.
Please refer to the ST application note "AN5231".
In general, it is recommended to verify the perfect position of the module in the target
application before fixing the design.
Antenna Placement Recommendation
Use a ground plane in the area surrounding the module wherever possible.
The dimensions are in millimeters.
It is recommended to place the module:
•
In the center (horizontal) of mother PCB.
•
At the edge (horizontal) of mother PCB.
Module Integration Guide Rev. 1.0
Top View
min. 18.00
5.00
Keep out
Area
Pin 1
Edge of
marking
mother PCB
3.50
Top View
4.80
Temp/Hum
Sensor
PAN3012
14.00
min. 18.00
5.50
3.30
Magneto
meter
PAN3011
0.95
Magneto
meter
PAN3013
3.30
3 PAN301x Module
Page 12 of 30
Advertisement
Table of Contents
