Install (*) - New Holland W130D Service Manual

Engine - Install
W130 D WHEEL LOADER XR, NEW CAB TIER4B
W130 D WHEEL LOADER ZBAR NEW CAB TIER4B
WARNING
Hot liquid under pressure!
Never remove the filler cap or the recovery tank cap while the engine is running or the coolant is hot.
Let the system cool. Turn the filler cap to the first notch and allow any pressure to escape, and then
remove the filler cap. Loosen the recovery tank cap slowly to allow any pressure to escape.
Failure to comply could result in death or serious injury.
NOTE: emissions sensors mounted in the exhaust stream are sensitive to extreme vibrations. Use of tools that gen-
erate extreme vibrations, such as impact wrenches and hammers, will result in damage to emission sensors. Avoid
using these tools during any service procedure in close proximity of emission sensors. If the use of these tools cannot
be avoided, remove the sensors using extreme caution prior to performing any service procedure.
1. Engine mount bolt
2. Washer
3. Upper isolator
4. Lower isolator
1. Inspect the engine mounts. If the engine rubber isola-
tors require replacement, remove and discard the up-
per isolators (3) and lower isolator (4).
Install new upper isolators (3) and new lower isolators
(4).
Engine - Engine and crankcase
WE
WE
1
RAIL12WEL0130FA
5. Washers
6. Washer
7. Nut
8. Remote oil drain hose
51428248_EN 18/12/2017
10.1 [10.001] / 28
W0296A